Britax UNITY Instructions For Installation & Use page 32

INSTALLATION OF CAR'S UPPER
ANCHORAGE POINT
ONLY USE A 5/16 UNC GRADE 5 BOLT. IF THE
BOLT IS NOT THE CORRECT LENGTH THE CAR
MANUFACTURER'S HAND BOOK CAN PROVIDE
ADVICE ON THE CORRECT LENGTH BOLT.
CHILD RESTRAINTS MUST NOT BE ATTACHED
TO UNSOUND METAL OR TO WOOD, OR
SYNTHETIC STRUCTURES. WHEN DRILLING 9
MM HOLE DO NOT DRILL THROUGH FUEL LINES,
FUEL TANKS, ELECTRICAL WIRING, OR RADIO
SPEAKERS.
WEBBING STRAPS MUST BE PROTECTED FROM
SHARP CORNERS AND EDGES. THE ANCHOR
FITTING MUST BE USED ONLY AS DESCRIBED
ABOVE. IT MUST NOT BE HOOKED ONTO ANY
OTHER OBJECT.
CAR INSTALLATION ACCESSORIES
(From retailers of Safe-n-Sound products)
EXTRA ANCHOR KITS: Available for using the restraint in additional cars.
Re-order no: 0038
EXTENSION STRAPS: May be required for cars without a fixed parcel shelf.
Re-order no: 0035 (length 300mm) or
0036 (length 600mm)
GATED 3-BAR SLIDE (Locking clip): For converting lap-sash seat belt to lap belt, and
to obtain a better fit to the car where the fitted lock-off may not be suitable. Most cars will
not need this. Re-order no: 0215.
62
Instructions for Installation & Use - Series No. 40/A/2013
NOTE: Marking on
the top of a Grade 5
Bolt. Do not use any bolt
without these marks.
Front of Vehicle
200mm
min.
Fig.3.
Centre line of
seating position
ALTERNATIVE INSTALLATION IF SEATBELT
LAP-SASH SEAT BELT
If a seat belt will not stay tight, then a
Gated 3-Bar Slide may be used to prevent
loosening.
Obtain this part from most retailers of Safe-n
Sound products.
There may be two types of Gated Slides
available, Curved and Flat.
Before using the restraint, convert the lap-
sash seat belt by using the Gated 3-Bar Slide.
A. Hold the lap and sash straps together and fold as
shown. Slide the inner strap into the Gated 3-Bar
Slide followed by the outer strap.
B. The two straps should slide freely in the Gated 3-Bar
Slide slot.
C. Repeat previous step A for the other
slot in the Gated 3-Bar Slide.
Instructions for Installation & Use - Series No. 40/A/2013
LOOSENS
Curved Flat
Inner
strap
Faces
towards
restraint
Hollow side
Ensure the Lap portion of seat
belt is nearest to the restraint
63