Britax UNITY Instructions For Installation & Use page 31

INSTALLATION OF CAR'S UPPER
ANCHORAGE POINT
IF THE CAR IS FITTED WITH CHILD
RESTRAINT UPPER ANCHORAGE
POINT
Locate the upper anchorage point behind
the rear seating position. (Consult the car
owners handbook for the location of the upper
anchorage point). The upper anchorage point
should be directly behind and central to the
restraint. Remove thread plug from the parcel
shelf/floor/roof, etc. and install attachment bolt
and fitting as shown in Fig 1.
CAUTION: DO NOT OVERTIGHTEN
ATTACHMENT BOLT. OVERTIGHTENING
MAY FRACTURE OR BREAK BOLT.
MAXIMUM TORQUE IS 20 Nm(14.75 ft.lb.)
Note: Minimum of five full turns of attachment
bolt is required before tightening force is
applied.
60
Instructions for Installation & Use - Series No. 40/A/2013
UPPER ANCHORAGE FITTING
Fig.1.
Attachment Bolt
Lock washer
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Front of Vehicle
INSTALLATION OF CAR'S UPPER
IF THE CAR IS NOT FITTED WITH CHILD
RESTRAINT UPPER ANCHORAGE
POINTS
For Sedans only - Drill 9mm diameter hole
in the parcel shelf on the centre line of the
seating position as shown in Fig 3. Before
drilling the hole, check the underside for
accessibility. Install the attachment bolt as
shown in Fig 2. It is recommended that this
installation be carried out by a child restraint
fitting station or licenced motor mechanic.
For vehicles other than Sedans - In
Australia, consult your nearest child
restraint fitting station or traffic authority
for vehicle inspection to find the best,
correct position for the placement of the
upper anchorage point, and for the correct
attachment bolt length and use of spacers.
In New Zealand, consult the agent for the
vehicle. Note to Queensland purchasers:
The installation of anchorage points must be
approved by authorised officers appointed
by Queensland Transport. Authorised
officers can be sourced from all Queensland
Transport Customer Service and
Queensland Ambulance Service Centres.
Instructions for Installation & Use - Series No. 40/A/2013
ANCHORAGE POINT
UPPER ANCHORAGE
FITTINGS FOR SEDANS ONLY
Fig.2.
Attachment Bolt
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Reinforcing
washer (cone
downwards).
Lock washer
Secure nut
Front of Vehicle
61