Britax UNITY Instructions For Installation & Use page 24

HOW TO USE
REMOVING BABY & INFANT CARRIER FROM BASE
A. Loosen the top tether strap. Ensure that the adjuster does not fall on the baby.
B. Remove the top tether strap from the tether strap guides on the Infant Carrier.
C. Place top tether strap between the stabilising bar and the car seat back so that it will
not fall behind the seat or get trapped in the door. This will keep the top tether strap
visible and ready for use when the Infant Carrier is
put back in the car.
D. Rotate the Carry Handle to the "carry position" as
shown.
E. Grasp the handle with one hand then pull the Infant
Carrier release catch with the other hand. With the
catch lifted raise the Infant Carrier clear of the base.
Always ensure the handle is locked in position
before lifting.
F. When the Infant Carrier is clear of the base, carefully
remove it from the car.
Ensure the harness adjustment strap hook is connected
to the loop.
CAUTION:
The end of the harness adjustment strap is
connected to the cover to avoid tripping over
the end when carrying the Carrier. Ensure the
harness adjustment strap hook is attached
when carrying the carrier.
46
Instructions for Installation & Use - Series No. 40/A/2013
Lift
Pull Catch
Hook the harness adjuster strap
on to the loop to prevent tripping
over the strap.
REMOVING BABY FROM INFANT CARRIER
A. Rotate the carry handle to the "non-rocking position"
and ensure the Canopy is fully open.
B. Press the Harness Adjuster while pulling both shoulder
straps evenly to loosen the harness.
C. Press the red button on Harness Buckle to release both
harness tongues. Place buckle tongues through buckle
tongue holder's (if fitted) on each side of the cover or
padded insert otherwise place straps on each side of the
carrier clear of the infant.
D. Feed the infants's arms through each side of the harness.
Lift the baby out of the carrier.
NOTE: Once the baby gets heavier you may wish to leave the carrier in the car. In
this case you will need to disconnect or loosen the top tether strap before removing
the baby.
Instructions for Installation & Use - Series No. 40/A/2013
HOW TO USE
Buckle Tongue
Holder (if fitted)
47