Britax UNITY Instructions For Installation & Use page 34

TRAVEL SYSTEM
INTEGRAL LATCH
INSTALLATION INSTRUCTIONS PREPARING THE INFANT
CARRIER - LATCH METHOD
A. Remove baby from Infant Carrier.
You may need to remove the Britax Click & Go™ Adaptors (see page 72) to enable
fitment on some strollers.
B. Rotate handle into "carry position"
C. With the release catch depressed lift the Infant Carrier clear of the base hooks, and
remove from the car.
D. You may need to remove the Britax Click & Go™ Adaptors (see page 72) to enable
fitment on some strollers.
PREPARING THE STROLLER
A. Ensure the Stroller has been assembled correctly before fitting the Infant Carrier.
B. Open the Stroller, apply the brakes and lower the backrest to the fully reclined
position.
C. Remove the arm bar cover and store in the basket pocket.
* Refer to page 23 for handle position
66
Instructions for Installation & Use - Series No. 40/A/2013
1
then lift the release catch with the other hand.
Arm Bar cover removed
INSTALLING THE INFANT CARRIER INTO THE STROLLER -
LATCH METHOD
A. Ensure that the arm bar (or tray) is fully locked in position on both sides of the
armrests.
B. Position the Infant Carrier over the Stroller with the baby's head end of the Infant
Carrier over the Stroller arm bar (or tray).
C. Lower the Infant Carrier and ensure that it locates onto the Arm Bar, (or tray) and the
latches engage.
Latch
Arm Bar
Instructions for Installation & Use - Series No. 40/A/2013
TRAVEL SYSTEM
INTEGRAL LATCH
Arm Bar
Latch
Tray
67