Britax UNITY Instructions For Installation & Use page 25

Infant carrier birth to 12 months (approx.) safe n sound
Table of Contents

Advertisement

HOW TO INSTALL IN AN AIRCRAFT
HOW TO INSTALL USING AIRCRAFT LAP BELT
The Infant Carrier without base is suitable for use on aircraft.
The Infant Carrier must be used in accordance with the aircraft operators procedures,
and any directions from the aircraft operator, pilot or crew.
The Infant Carrier may not fit in smaller aircraft.
Inform the aircraft operator that a child restraint is intended to be used on the aircraft
when booking the flight as the child restraint may not be suitable for use in that
operator's specific aircraft.
Follow the instructions of the flight crew or pilot.
For use of the child restraint in cars in countries other than Australia and New Zealand,
The user should consult the country's local authorities, car hire companies, car insurance
companies, etc. for advice. The child restraint may not be acceptable for use in all cars.
FIT THE INFANT CARRIER TO THE
AIRCRAFT SEAT
You do not need the base and we recommend that you
check it in with your luggage.
A. Position the infant carrier rearward facing, align it
centrally within the allocated seating position. If
possible, lift the armrests out of the way to improve
access to installing the aircraft lap belt and to suit the
width of the carrier.
B. Carefully remove cover on the side to reveal
AIRCRAFT REARWARD-FACING BELT
PATH
label marked in green.
NOTE: Never use this path in a car
48
Instructions for Installation & Use - Series No. 40/A/2013
AIRCRAFT
REARWARD-FACING
BELT PATH
marked in green.
B
HOW TO INSTALL IN AN AIRCRAFT
C. Place handle in "non-rocking" position,
that is, fully backwards. Fully lengthen lap
AIRCRAFT
belt. Thread the lap belt into
REARWARD-FACING BELT
PATH
lap belt path (green marker) as
shown, ensuring that lap part is below the
hook as shown, on each side. Engage lap
belt buckle and tongue.
D. Push down on the infant carrier and remove
all slack from the lap belt. Pull belt strap to
tighten, ensure a firm fit of the infant carrier
to the seat.
Do not use this restraint with aircraft seatbelt
that contain airbags. The aircraft operator
may replace them.
Instructions for Installation & Use - Series No. 40/A/2013
C
Ensure lap
belt is under
the hook on
each side
D
Remove slack
49

Advertisement

Table of Contents
loading

This manual is also suitable for:

Safe-n-sound unity

Table of Contents