Kipor SINEMASTER IG1000 Operation Manual page 23

Sinemaster
Hide thumbs Also See for SINEMASTER IG1000:
Table of Contents

Advertisement

2. Start the engine.
■ The DC receptacle may be used while the AC power is in use.
■An overload DC circuit will trip the DC circuit protector. If this happens, wait a few minute before
pushing in the circuit protector to resume operation.
In order to acquire both the best effect and the maximum service life of the generator, usually, the
new generator should run 20 hours under 50% loads, the generator may reach the best
performance.
Low oil alarm system
The Low oil alarm system is designed to prevent engine damage caused by an insufficient amount
of oil in the crankcase. Before the oil level in the crankcase falls below a safe limit, the Low oil
alarm system will automatically shut down the engine (the engine switch will remain in the ON
position).
■The battery gives off explosive gases; Keep sparks flames and
cigarettes away. Provide adequate ventilation when charging.
■The battery contains sulfuric acid (electrolyte). Con-tact with skin or
eyes may cause severe burns. Wear protective clothing and a face
shield.
-If electrolyte gets on your skin, flush with water.
-If electrolyte gets in your eyes, flush with water for at Least 15
minutes and call a physician.
■Electrolyte is poisonous.
-If swallowed, drink large quantities of water or milk and follow with
milk of magnesia or vegetable oil and call a physician.
■KEEP OUT OF REACH OF CHILDREN.
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinemaster ig1000s

Table of Contents