Kipor SINEMASTER IG1000 Operation Manual page 20

1. Connect the ground terminal.
2. Start each engine according to "STARTING THE ENGINE".
When the output indicator light (green) does not light and the overload indicator light (red) lights
instead, set the engine switch to STOP, stop the engine at once and then start the engine again.
3. Confirm that the equipment to be used is switched off, and insert the plug of the equipment to be
used into the AC receptacle of unit A or unit B.
■Confirm that the use equipment to be connected is switched off.
■When the equipment to be used is switched on, it will operate
suddenly, and injuries or accidents may be caused.
20