Ending Clamp Change Mode - DURKOPP ADLER 906 Operating Instructions Manual

Installing the transfer plate
Figure 26: Installing the transfer plate
(1) - Transfer plate
1. Slide the transfer plate (1) as far as the stopper (2) into the bracket and
2. Press the 3 button on the screen.
 The locking device is closed.

5.12.4 Ending clamp change mode

The clamp change mode can only be ended once all locking devices are
closed on the configuration set.
1. Tap the OK button on the screen.
Important: The contour must be within the boundaries of the sewing field.
Open an appropriate sequence for the configuration set ( 7.5 Opening
a seam program or sequence for sewing, page 74).
42
①
hold it in this position.
ATTENTION
The machine can be damaged by exceeding the size of the sewing
field.
If the sequence or seam programs do not match the configuration set,
the movement of the clamps during sewing can cause damage to the
machine or the sewing material.
Ensure that sequences and seam programs are only used which are
suitable for the configuration set.
(2) - Stopper bracket
Operating instructions 906 - Version 00.0 - 05/2014
Operation
②