DURKOPP ADLER 906 Operating Instructions Manual page 124

Error
code
4201
5301
6551
6554
6651
6653
6751
6761
6952
Communication
7801
8151
8156
8159
8154
8252
8257
8258
8256
8254
8351
9601
9700
9701
9900
9901
9902
122
Description
Internal CF card defective
Program cannot be sewn
Error in upper part position/AD
converter/process error
Internal error
Stepper motor driver error
Internal error
Control panel interface communication
• Cable fault
• Cable
IDMA error
• Fault
• Controller defective
8152 IDMA error
• Internal error
ADSP Boot/Xilinx Boot/ Boot error
Fault
Test pins error
Stop while sewing on the contour
Continue sewing?
Bobbin change flap not closed
Parallel clamps not lowered
Incorrect machine parameter
Incorrect sequences
Incorrect program parameter
Error and information messages
Remedy
• Switch the machine off and on again
• Retrofit/replace controller
Copy program to DAC
• Switch the machine off and on again
• Software update
• Notify DA Service
• Switch the machine off and on again
• Software update
• Notify DA Service
• Switch the machine off and on again
• Software update
• Notify DA Service
• Switch the machine off and on again
• Replace the controller
• Switch the machine off and on again
• Software update
• Notify DA Service
• Switch the machine off and on again
• Switch the machine off and on again
• Software update
• Notify DA Service
• OK button =
Continue sewing
• ESC button =
Cancel sewing
Close the bobbin change flap
• Remove obstacles
• Adjust sensors
Initialize the data
Initialize the data
Initialize the data
Operating instructions 906 - Version 00.0 - 05/2014