DURKOPP ADLER 906 Operating Instructions Manual page 104

102
MP2 - Limit values
Symbol Meaning
Max. speed
(min. = 500 .. max. = 3000; Def. =2700 rpm)
All sewing programs are limited to this maximum speed.
Max. run-empty speed
(min. = 10 .. max. = 100; Def. = 100 %)
Limits all clamp movements of the outer frame/inner slider between the
seams to this value.
Transport start angle
(min. = 30 .. max. = 350; Def. = 210 °)
The movement of the outer frame/inner slider during the stitch starts at this
angle of needle motion.
Transport phase
(min. = 30 .. max. = 100; Def. = 100 %)
This parameter defines how the outer frame/inner slider is to be moved
during the stitch.
(A value of 100 % means that the desired outer frame/inner slider motion is
distributed over the entire stitch.)
Needle reversing position
(min. = 0 .. max. = 359; Def. = 0 °)
The needle is reversed at this angle in order to increase the clearance to
the outer frame/inner slider.
Edit time paths
This function is only for Dürkopp Adler Service personnel.
MP3 - Needle thread monitor
Symbol Meaning
Needle thread monitor mode
The following options are available:
Threading position: After detection of a thread breakage the thread is cut
and the outer frame/inner slider then moves to the threading position.
Cut thread (Def.): After detection of a thread breakage, the thread is cut
and the outer frame/inner slider then moves to the contour position accord-
ing to the defined reversing path.
Remain in position: After detection of a thread breakage, seam motion is
stopped.
Not active: The needle thread monitor is ignored.
Reversing path after thread breakage
(min. = 0 .. max. = 20; Def. = 5 stitches)
Number of stitches to be taken into account when reversing after a thread
breakage.
Bobbin change X position
The value range varies depending on the subclass and sewing field size.
Settings via the software
Operating instructions 906 - Version 00.0 - 05/2014