Figure 23: Disassembly - Nanoptix PayCheck Slim Service Manual

Instruction E: Disassembly of printing mechanism kit
1. Remove print mechanism kit by following Instruction A
2. Cut tie wrap
3. Remove mech mount mounting screw
4. Separate mechanism by sliding mount upwards
5. Push sensor out using a screw driver
6. Remove print head by prying with a small screw driver
(Make sure not to apply any pressure to the print head white flat cable)
7. Remove head by pushing down and back
(Attention: springs may pop out of position)
Document # 720006-0000
August, 2011

Figure 23: Disassembly

Service Manual
31