Commissioning; Getting Started; Before You Start; Test Audio Hook-Up - SoundCraft RM1ds User Manual

Digital radio console

Table of Contents

Commissioning

The goal of this section is to quickly take you through the installation procedure and basic

features of the RM1d.

We will get a signal into the console on Channel 1, give it a custom name, route it to the Mix

outputs, add some EQ and then add some Reverb.

Ensure the DPS-2 power supply is NOT connected to the Mains and is turned OFF.

The Power supply can be positioned anywhere within reach of the RM1d and an available

power socket, but is best rack-mounted in a position where airflow through the vents is not

obstructed and where the power switch or cables cannot be accidentally knocked.

Although not essential to the correct operation of the RM1d, a maintained power feed (UPS) is

recommended to protect the station output in case of mains failure. However, if an UPS is to be

shared with other items of equipment, ensure that the total load does not exceed the rated

specification of the UPS.

Connect the multi-way power cable between the DPS-2 External Power Supply and the RM1d

Power connector. Screw the connector locking ring clockwise on both units to secure the cable.

The locking ring should be firm, but not tight. Connect an IEC type mains cable with the plug

fused at 3 AMPS, to the mains input socket on the DPS-2. Connect the other end to the nearest

plug socket and switch on the power to the DPS-2.

The RM1d should take around 40 seconds to boot up. Please be patient! (It is quite normal for

all the LEDs on the control surface to light up while booting).

For the purpose of this section we will simply use a microphone connected to a MIC/LINE Input.

It is assumed that an amplifier with some speakers is connected to the Left and Right STE 1

(PROG) outputs.

NOTE: This is a TEST configuration only. The STE outputs are normally used to carry station

output. Speakers should normally be connected to the MONITOR outputs.

Before starting, make sure that both STE Main Faders are at - infinity to prevent any unexpected

feedback.

RM1d/RM1ds User Guide

Table of Contents

Rm1d