Installation (Attach The Al-200 To The Machine Which Is Installed The Op-150 And If-300.) - Muratec F-360 Field Engineering Manual

Installation
Attaching the AL-200 to a machine that has a PCL option installed
1. Open the top cover.
Remove the rear cover.
Disconnect the speaker connector, and then remove the rear cover.
Remove the Shield plate.
2. Remove the harness cover from the rear cover.
You will pass the connection cable through this hole.
H a r n e s s C o v e r
3. Remove four screws on the cover of the second phone line module. Then remove the cover.
4. Remove the angle plate mounting screw. Then remove the four angle plates.
6-13