Receive Errors; Will Not Auto-Answer; Clearing Jammed Paper - Muratec F-360 Field Engineering Manual

4.8 Receive Errors

Symptom: Check message prints after attempting a reception.
Suggested corrective action:
1. Reference the error code on the check message or the journal to the error code list contained in this
section.

4.9 Will not Auto-Answer

Symptom: The unit rings but will not auto-answer.
Suggested corrective action:
1. Check the power cord and AC switch.
2. Verify the telephone line is properly installed.
3. Verify recording paper in the paper cassette.
4. Check the memory capacity. The unit will not answer incoming calls if memory full.
5. Check the number of rings is set to answer on. If set to a high number of rings, the transmitting unit
may "time out".
6. Insure the unit is in the Fax Ready mode.
7. Check the operation of the NCU PCB and the main control PCB.

4.10 Clearing Jammed Paper

To remove the document:
1. Open the scanner cover. If you can remove the document, remove it and skip to step 3.
If not, proceed to step2.
2. Open the inner cover and lift the document from the machine.
3. Gently close the scanner cover, making sure both sides are snapped down securely.
Note: If the original document has become wrinkled or torn, do not re-send it.
4-4