Sram Check - Muratec F-360 Field Engineering Manual

3.12.5 SRAM Check

This mode is used to test the SRAM memory where user programmed parameters such as date, time, TTI,
etc. are stored.
Note: When this test is executed, the unit will perform an All RAM Clear.
The All RAM Clear erases all user settings and resets all memory switches, machine parameters and unique
switches to factory defaults.
1. Press MENU, *, 1, 1. Select "SRAM Check" using the cursor key.
2. Press ENTER. The machine will start the SRAM check.
Note: To finish the operation without performing SRAM check, press STOP.
The data is written to, then read from, each address. The results are shown in the display.
If the read/write test is successful the display will show "OK".
If some portion of the read/write test fails, the display will show "NG" with the address and the data name.
3-111