Table of Contents
Advertisement
Pattern Setup
PATTERN SETUP
------------------------
PATTERN NO.
CLR PATTERN
RUN PATTERN
<EDIT PATTERN>
BACK
EXIT
Pattern Edit
EDIT PATTERN 1
------------------------
MOVE TO START POSITION
[NEAR:START /FAR:CANCEL]
EDIT PATTERN 1
[NEAR:SAVE
/FAR:DELETE]
Speed Dome Camera Instruction Manual
Pattern Number
1
UNDEFINED
CANCEL
Clear Pattern
Run Pattern
Edit Pattern
① With the joystick controller, move the camera to
the
magnification. To start the pattern recording, press
NEAR key. To exit, press FAR key.
② Move the camera with the joystick controller or run
a preset function to memorise the path in the
selected pattern. The joystick movements and preset
movements will be memorised in a pattern. After
a pattern is programmed, the remaining storage
is displayed in the progress bar on the screen.
③ To save the data and exit, press NEAR key. To cancel
saving the data and delete the data, press FAR key.
0/0/x1/N
[1~4 ]
Selects a Pattern number to edit. If the
selected
defined,
displayed under the selected pattern
number.
[CANCEL/OK]
Deletes the data of the selected pattern.
Runs the Pattern for test purposes to
check if it works properly.
Edits the selected pattern.
start
position
with
OSD MENU
pattern number is not
"UNDEFINED"
will
an
appropriate
4
be
zoom
41/50
Advertisement
Table of Contents
