Swing Setup - Genie CCTV ASD276 Instruction Manual

Swing Setup

SWING SETUP
------------------------
SWING NO.
1ST POS.
2ND POS.
SWING SPEED
CLEAR SWING
RUN SWING
BACK
EXIT
Speed Dome Camera Instruction Manual
Swing
Number
1
NOT USED
NOT USED
1st Position
30/SEC
CANCEL
2nd Position
Swing
Speed
Clear Swing
Run Swing
[1~8]
Selects a Swing number to edit. If the
selected Swing is not defined, "NOT USED"
is displayed in the 1st Position and the 2nd
Position.
[PRESET 1~128]
Sets the 2 positions for a Swing function. If
the selected preset
"UNDEFINED" is displayed as shown
below.
SWING SETUP
------------------------
SWING NO.
1ST POS.
2ND POS.
When a swing function runs, the camera
moves from the preset assigned as the 1st
point to the preset assigned as the 2nd
point in a clockwise direction. Then
the camera moves
assigned as the 2nd point to the preset
assigned as the 1st point in a
counterclockwise direction. In cases where
the preset assigned as the 1st point and the
preset assigned as the 2nd point are same
or only 1 Preset position is assigned, the
camera turns on its axis by 360° in a CW
direction and then it turns on its axis by
360° in a CCW direction.
[1°/sec. ~180°/sec.]
Defines Swing speed between the 2 Preset
positions from 1°/sec to 180°/sec
[CANCEL/OK]
Deletes the data of the selected Swing.
Runs Swing for test purposes to check
if it works properly.
4
OSD MENU
is not defined,
1
PRESET5
NOT USED
UNDEFINED
from the preset
40/50