Preset; Swing - Genie CCTV ASD276 Instruction Manual

Preset

Function
Setting Presets
Running Presets
Deleting Presets

Swing

Function
Setting Swings
Running Swings
Deleting Swings
Speed Dome Camera Instruction Manual
MAX. 127 positions are programmable. The Preset number can be
assigned from 1 to 128 except 95. Preset 95 is reserved for entering
into OSD menu. Camera parameters such as White Balance, Auto
Exposure and others can be set up independently and each preset
can have its own parameter values independently from the other
presets. When setting up presets with a controller, Label should be
blank and "Camera Adjust" should be set to "GLOBAL" as the default.
To change the parameters, enter into OSD menu.
Set Preset [1~128]
Go Preset [1~128]
To delete Presets, enter into OSD menu.
With this function the camera moves repetitively between two
preset positions at programmed speeds. When a swing function runs,
the camera moves from the preset assigned as the 1st point to the
preset assigned as the 2nd point in a clockwise direction. Then
the camera moves from the preset assigned as the 2nd point to the
preset assigned as the 1st point in a counter clockwise
direction.
1st Preset
When the preset assigned as the 1st point and the preset
assigned as the 2nd point are the same, the camera turns on its
axis 360° in a clockwise direction and then it turns back on its axis
360° in a counter clockwise direction. The Swing speed is
defined from 1°/sec to 180°/sec.
To set Swing, enter into OSD menu.
Method 1) <Run Pattern> [Swing NO. + 10]
Method 2) <Go Preset> [Swing NO. + 140]
To delete Swings, enter into OSD menu.
OPERATION
2nd Preset
ex. Run Swing 3 : <Run Pattern> [13]
ex. Run Swing 3 : <Go Preset> [143]
3
21/50