Installation With Ceiling Mount Bracket - Genie CCTV ASD276 Instruction Manual

Installation with Ceiling Mount Bracket

① Remove the ceiling tile from the ceiling
and cut a hole whose diameter is
30~40mm in the ceiling tile to pass the
wire(s) and cable(s) through to the upside
of the ceiling (in case of the wiring and
cabling through the mounting surface
only). Then prepare the ceiling mount
bracket. Pull the wire(s) for the system as
below (Anchor Bolt 3/8"×70).
③ Screw the dome cover to the main body
and remove the protective vinyl from the
dome cover.
Important Notice
Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
To adjust the installation height from the mounting surface, a pole and coupler could be needed
between the surface mount part of the ceiling mount bracket and the camera mount part of the ceiling
mount bracket. Note that these are not supplied by the manufacturer.
Speed Dome Camera Instruction Manual
② Pull the wire(s) and cable(s) for the
system as below. Wire the cable(s) to the
ports. Insert the mounting hooks into the
holes on the surface of the main body and
turn the main body. Assemble the main
body with the camera mount adaptor and
the 3 screws. (Machine M5×15)
INSTALLATION
14/50
2