Display Setup - Genie CCTV ASD276 Instruction Manual

Display Setup

DISPLAY SETUP
------------------------
CAMERA ID
PTZ INFORMATION
ACTION TITLE
PRESET LABEL
ALARM I/O
<SET NORTH DIRECTION>
<PRIVACY ZONE>
BACK
EXIT
Speed Dome Camera Instruction Manual
Display setup allows programming of how labels are
displayed on the monitor. In AUTO, the labels are only
displayed on the monitor when there are any changes in
ON
parameters.
AUTO
AUTO
Camera ID
AUTO
AUTO
PTZ Information
Action Title
Preset Label
Alarm I/O
[ON/OFF]
Displays the selected
(Address).
[ON/OFF/AUTO]
Displays the amount of pan from zero
degree vertical, the amount of tilt from
zero degree horizontal and current
compass direction. Also identifies the
amount of the zoom magnification.
[ON/OFF/AUTO]
Identfies Actions.
"SET PRESET xxx"
"PRESET xxx"
"PATTERN x"
"SWG/PRESET xxx"
"UNDEFINED"
[ON/OFF/AUTO]
Displays the preset labels when the
camera arrives at presets.
[ON/OFF/AUTO]
Displays the activated alarms. This
information shows the current state of
Alarm Inputs and Relay Outputs. If an
Input point is ON state, it will show a
number corresponding to each point. If
an Input point is OFF state, '-' will be
displayed.
Example: Input points 2 & 3 are
ON and Output is ON, OSD will show as
below.
I:-23 O:1
4
OSD MENU
Camera ID
27/50