Pattern - Genie CCTV ASD276 Instruction Manual

Vandal resistant ptz day/night camera
Table of Contents

Advertisement

Pattern

Function
Setting Patterns
Running Patterns
Deleting Patterns
Note) When the system memorises Patterns, the commands are stored in memory, not
the positions of Pan/Tilt/Zoom. Hence there might be small differences between the original
path and the revived path by path type of Patterns. Note that it is not a problem in position
precision.
Speed Dome Camera Instruction Manual
With this function the camera memorises the path (mostly curve paths)
created by the joystick controller and then mimics the joystick movements
as closely as possible.
MAX.
4
Patterns
communication commands can be programmed in a pattern.
A Pattern can be created using the following method.
Method 1) <Set Pattern> [Pattern NO.]
The Pattern programming window appears on the monitor as
below.
EDIT PATTERN 1
[NEAR:SAVE
The movement of the Joystick and the preset movement can
be memorised in a pattern.
After a pattern is programmed, the remaining storage is
displayed in the progress bar on the screen.
To save the recording press the NEAR key and to cancel press
FAR key.
Method 2) Programming in OSD Menu : See the section "How to use OSD Menu".
Method 1) <Run Pattern> [Pattern NO.]
Method 2) <Go Preset> [Pattern NO. + 130]
To delete Patterns, enter into OSD menu.
are
programmable
/FAR:DELETE]
0/0/x1/N
ex) Run Pattern 2 : <Run Pattern> [2]
ex) Run Pattern 2 : <Go Preset> [132]
OPERATION
and a Maximum
22/50
3
1200

Advertisement

Table of Contents
loading

This manual is also suitable for:

Asd376

Table of Contents