Check Points Before Operation; Check Points For Preset And Pattern Function Before Operation - Genie CCTV ASD276 Instruction Manual

Check Points before Operation

Before turning on the system, check that the wire(s) and cable(s) are properly connected.
Check if the camera ID on the controller is properly selected. The camera ID must be
identical to that of the target camera. The camera ID can be checked by reading the DIP
switch of the camera or on the OSD.
If your controller supports multi-protocols, the protocol must be changed to match to that of
the camera.
Adjust the DIP switch after turning off the camera. If the camera protocol is changed when
the power is still applied, the change is only effective after rebooting the camera.
Since operation methods can be different by controllers, refer to your controller manual
if the camera cannot be controlled properly. The operation of this manual is based on the
standard Pelco® Controller.

Check Points for Preset and Pattern Function before Operation

Check fully, in advance, how to operate the preset and pattern function on your controller
or DVR.
Refer to the following table when using standard Pelco® protocol controllers.
< Go Preset >
< Set Preset >
< Run Pattern >
< Set Pattern >
If your controller or DVR has no pattern button or function, use the Hot Keys with preset
numbers. For more information, refer to "Reserved Presets(Hot Keys)" in this manual.
Speed Dome Camera Instruction Manual
Input [Preset Number] and press [Preset] button shortly.
Input [Preset Number] and keep pressing [Preset] button for more than 2 seconds.
Input [Pattern Number] and press [Pattern] button shortly.
Input [Pattern Number] and keep pressing [Pattern] button for more than 2 seconds.
3
OPERATION
19/50