System Event Log; Integrated Management Module (Imm) Error Messages - IBM System x3550 M3 Type 4254 Problem Determination And Service Manual

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, "Parts listing, System x3550 M3 Types 4254 and 7944," on page 159 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units
(FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
v Go to the IBM support Web site at http://www.ibm.com/systems/support/ to check for technical
information, hints, tips, and new device drivers or to submit a request for information.
Error code Description
3818007 CRTM update capsule signature invalid
3828004 AEM power capping disabled

System event log

The system event log contains messages of three types:
Information
Warning
Error
Each message contains date and time information, and it indicates the source of
the message (POST or the IMM).

Integrated management module (IMM) error messages

The following table describes the IMM error messages and suggested actions to
correct the detected problems. For more information about IMM, see the Integrated
Management Module User's Guide at http://www.ibm.com/systems/support/
supportsite.wss/docdisplay?lndocid=MIGR-5079770&brandind=5000008.
38
IBM System x3550 M3 Types 4254 and 7944: Problem Determination and Service Guide
Information messages do not require action; they record significant
system-level events, such as when the server is started.
Warning messages do not require immediate action; they indicate possible
problems, such as when the recommended maximum ambient temperature
is exceeded.
Error messages might require action; they indicate system errors, such as
when a fan is not detected.
Action
1. Run the Setup utility, select Load Default
Settings, and save the settings.
2. (Trained service technician only) Replace the
system board.
1. Check the settings and the event logs.
2. Make sure that the Active Energy Manager feature
is enabled in the Setup utility. Select System
Settings, Power, Active Energy, and Capping
Enabled.
3. Update the server firmware to the latest level (see
"Updating the firmware" on page 255).
4. Update the IMM firmware to the latest level (see
"Updating the firmware" on page 255).