Removing An Adapter - IBM System x3550 M3 Type 4254 Problem Determination And Service Manual

Removing an adapter

To remove an adapter, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords; then,
3. Disconnect any cables from the adapter.
4. Grasp the riser-card assembly at the rear edge and lift to remove the riser-card
5. Place the riser-card assembly on a flat, static-protective surface.
6. Carefully grasp the adapter by its top edge or upper corners, and pull the
7. If you are instructed to return the adapter, follow all packaging instructions, and
on page 167.
remove the cover (see "Removing the cover" on page 174).
assembly.
adapter from the riser-card assembly.
use any packaging materials for shipping that are supplied to you.
Chapter 5. Removing and replacing server components
179