Removing An Optional Dvd Drive - IBM System x3550 M3 Type 4254 Problem Determination And Service Manual

Removing an optional DVD drive

To remove an optional DVD drive, complete the following steps:
1. Read the safety information that begins on page "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the server cover (see "Removing the cover" on page 174).
4. Press and hold the release tab down as you push the drive from the rear to
5. Slide the drive retention clip from the side of the drive. Save the clip to use
6. Attach the drive retention clip to the side of the DVD drive filler panel hat you
7. Slide the DVD drive filler panel into the DVD drive bay until the DVD drive filler
"Installation guidelines" on page 167.
slide it out of the bay.
when you install the replacement drive or replace the DVD drive filler panel.
removed in step 6 on page 190.
panel clicks into place.
Chapter 5. Removing and replacing server components
189