Removing A Sas/Sata 4 Pac Hdd Option; Installing A Sas/Sata 4 Pac Hdd Option - IBM System x3550 M3 Type 4254 Problem Determination And Service Manual

10. Turn on the peripheral devices and the server.

Removing a SAS/SATA 4 Pac HDD option

To remove a SAS/SATA 4 Pac HDD option, complete the following steps:
1. Read the safety information that begins on page vii and the "Installation
2. Turn off the server and peripheral devices and disconnect the power cords and
3. Remove the cover (see "Removing the cover" on page 174).
4. Pull the hard disk drives and filler panels out of the server slightly to disengage
5. Remove the bezel (see "Removing the bezel" on page 227).
6. Slide the optional hot-swap hard disk drive cage out of the chassis and set it

Installing a SAS/SATA 4 Pac HDD option

You can install an IBM System x3550 M3 Hot-swap SAS/SATA 4 Pac HDD option to
add four additional 2.5-inch hot-swap hard disk drives in the server. See
http://www.ibm.com/servers/eserver/serverproven/compat/us/ for a list of supported
optional devices. To order a SAS/SATA 4 Pac HDD option, contact your IBM
marketing representative or authorized reseller.
The SAS/SATA 4 Pac HDD option kit contains the following components:
v One 2.5-inch hard disk drive backplane (with bracket)
v Four drive bay filler panels
v One SAS signal cable
v One 4 Pac hard disk drive cage and screws
v One bezel (depending on the option you purchase)
To install a SAS/SATA 4 Pac HDD option, complete the following steps:
232
IBM System x3550 M3 Types 4254 and 7944: Problem Determination and Service Guide
6. Reinstall the fans (see "Installing a hot-swap fan assembly" on page 215).
7. Replace the cover (see "Installing the cover" on page 174).
8. Slide the server into the rack.
9. Reconnect the power cord and any cables that you removed.
guidelines" on page 167.
all external cables.
them from the hard disk drive backplane.
aside.
Bezel
1. Read the safety information that begins on page vii and the "Installation
guidelines" on page 167.
Hard disk drive cage