Seagull Models SPORT CRUISER Assembly Manual page 23

Sport cruiser seagull models
Table of Contents

Advertisement

INSTALLATION PILOT AND CANOPY.
1) Locate items necessary to install pilot, and
canopy.
2
2) A scale pilot is included with this ARF. The
Seagull Pilot included fitting well to the cockpit.
(or you can order others scale pilot figures
made by Seagull factory. They are available at
Seagull distributors.)
If you are going to install a pilot figure, please
use a sanding bar to sand the base of the figure
so that it is flat.
3) Position the pilot figure on the canopy floor
as show. Locate the oval shaped on the canopy
floor and remove the covering. Use epoxy to
glue this into the base of the pilot figure and
glue the cockpit panel in place with C/A glue,
please see pictures as shown.
8mm.
2
C/A glue.
www.seagullmodels.com
1
3
170mm.
C/A glue.
1
C/A glue.
INSTALL THE PLASTIC PARTS.
1) Locate the items neccessary to install the
plastic parts included with your models:
Antenna.
2) Position the plastic parts onto the canopy
and fuselage and apply C/A glue and hold the
plastic parts secure until the glue fully cures.
Please see pictures below.
M2x6mm.
23

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SPORT CRUISER and is the answer not in the manual?

Table of Contents