Brakes - BRP Spyder RT Operator's Manual

Brakes

WARNING
New brakes will not operate at
their maximum efficiency until
their break-in is completed. Brak-
ing performance may be reduced,
so use extra caution. Brakes take
about 300 km (200 mi) of riding
with frequent braking to break-in.
For riding with infrequent braking,
allow extra time to break-in the
brakes.
Brake Fluid Level Verification
Use only DOT 4 brake fluid from a
sealed container.
Check the brake fluid level as follows:
1. Park the vehicle on a firm, level sur-
face.
2. Unlatch and lift the seat
THE SEAT
.
rmo2010-001-013_b
1. Brake fluid reservoir
3. Check the brake fluid level in both
reservoirs, near the back of the seat.
They should both be above the MIN.
mark.
rmo2010-001-091_a
1. Brake fluid MAX. level mark
2. Brake fluid MIN. level mark
OPENING
rmo2010-001-092_a
A. Operating range
4. Add fluid as required.
NOTE: Low brake fluid may indicate
leaks or worn brake pads. See an au-
thorized Can-Am roadster dealer.
Adding Brake Fluid
Remove the filler cap.
Clean filler cap before removing.
Use only DOT 4 brake fluid from a
sealed container.
1. Add fluid to MAX level.
NOTICE
painted surfaces or plastic parts.
Wipe up any spills.
2. Reinstall filler cap as follows:
______________
MAINTENANCE PROCEDURES
WARNING
Brake fluid can damage
2.1 Check that V slit is in good con-
dition.
2.2 Ensure diaphragm are prop-
erly positioned.
139