Headlight Switch - BRP Spyder RT Operator's Manual

SECONDARY CONTROLS
NOTE: The cruise control status will
show CRUISE OFF in the digital dis-
play.
Cancelling the Cruise Control
Any of the following event will cancel
the cruise control and give you back
the throttle control. It then can be re-
sumed if desired.
– Pressing the brake pedal.
– Squeezing the clutch lever or if
clutch slippage occurs (SE5 mod-
els).
– Gear change (SE5 model).
– Any vehicle stability system inter-
vention.
NOTE: When cancelling the cruise
control, you may activate the throt-
tle lever up to the desired position to
make the transition smoother.
Resuming the Cruise Control
If the cruise control was cancelled and
the cruise control switch is still at the
ON position, the cruise control oper-
ation can be resumed by pushing the
cruise control button up. The cruise
control will then recover the previous
set speed.
rmo2010-001-031_i
CRUISE CONTROL PREVIOUSLY
CANCELLED
1. Push up button to RESUME
NOTE: The cruise control status will
show CRUISE SET in the digital dis-
play.
______________
20

6) Headlight Switch

Headlights
The switch is near the left handgrip.
rmo2010-001-020_b
1. Headlight switch
The switch is used to select high or low
beam for the headlight. The headlights
automatically turn on when the engine
reaches 800 RPM and turn off after ap-
proximately 20 seconds when engine
has been stopped.
To select high beams, push the switch
to the front position. To select low
beams, push the switch to the back
position.
To flash the high beams, press the
switch to the down position, then re-
lease it. The high beams will stay on as
long as you hold down the switch.
rmo2010-001-020_f
1. High beams
2. Low beams
3. Flash high beams