Ricoh C23535 Operating Instructions Manual page 448

Troubleshooting When Using the Facsimile Function
Problem
Misfeeds occur frequently. The paper is damp.
Misfeeds occur frequently. The paper is too thick or
Misfeeds occur frequently. The copy paper is wrin-
3
Copy paper becomes
creased.
Copy paper becomes
creased.
Copy paper becomes
creased.
Images are only partially
printed.
Black lines appear on the
print produced at the
destination.
Background of received
images appears dirty. Im-
ages from the back of the
page appear.
Printed or sent images
are spotty.
Received image is too
light.
Received image is too
light.
Received image is too
light.
42
Cause
too thin.
kled or has been fold-
ed/creased.
Printed paper is being
used.
The paper is damp.
The paper is too thin.
The paper is damp.
The exposure glass or
scanning glass is dirty.
Image density is too high. Adjust scan density. See "Image Densi-
The ADF, exposure glass
or scanning glass is dirty.
When using moist, rough,
or processed paper, areas
of print may not be fully
reproduced.
When D is blinking, ton-
er is beginning to run out.
• The image density has
been set too low.
• The original of the
transmitted fax was
printed on paper that
is too thin.
Solution
Use paper that has been stored in the
recommended temperature and hu-
midity condition. See "Copy Paper",
About This Machine.
Use recommended paper. See "Copy
Paper", About This Machine.
Use recommended paper. Use paper
that has been stored in the recommend-
ed temperature and humidity condi-
tion. See "Copy Paper", About This
Machine.
Use recommended paper. See "Copy
Paper", About This Machine.
Use paper that has been stored in the
recommended temperature and hu-
midity condition. See "Copy Paper",
About This Machine.
Use recommended paper. See "Copy
Paper", About This Machine.
Use paper that has been stored in the
recommended temperature and hu-
midity condition. See "Copy Paper",
About This Machine.
Clean them. See p.122 "Maintaining
Your Machine".
ty (Contrast)", Facsimile Reference.
Clean them. See p.122 "Maintaining
Your Machine".
Make sure that ink or correction fluid is
dry before placing originals.
Only use recommended paper. See
"Copy Paper", About This Machine.
Add toner. See p.89 "Adding Toner".
• Increase the scanning density. See
"Image Density (Contrast)", Fac-
simile Reference.
• Ask the sender to reprint the origi-
nal on thicker paper and fax it again.