Headlight Adjustment; Co Check - PIAGGIO NRG Power DT Workshop Manual

Maintenance
ID AND THE BLEEDING OF AIR FROM THE
CIRCUITS.
Recommended products
AGIP BRAKE 4 Brake fluid
FMVSS DOT 4 Synthetic fluid

Headlight adjustment

Proceed as follows:
1. Place the vehicle in running order and with the
tyres inflated to the prescribed pressure, on a flat
surface 10 m away from a white screen situated in
a shaded area, making sure that the longitudinal
axis of the vehicle is perpendicular to the screen;
2. Turn on the headlight and check that the bor-
derline of the projected light beam on the screen
is not lower than 9/10 of the distance from the
ground to the centre of vehicle headlamp and high-
er than 7/10;
3. Otherwise, regulate the headlight by adjusting
the screw «A», after removing the front grille.
N.B.
THE ABOVE PROCEDURE COMPLIES WITH
THE EUROPEAN STANDARDS REGARDING
MAXIMUM AND MINIMUM HEIGHT OF LIGHT
BEAMS. REFER TO THE STATUTORY REGU-
LATIONS IN FORCE IN EVERY COUNTRY
WHERE THE vehicle IS USED.

CO check

In the event that the exhaust on the vehicle being
tested does not have an exhaust gases collection
port, proceed as follows:
- Remove the R.H. side fairing
- Remove the secondary air box cover with the
aluminium cap by acting upon the clamp shown in
the figure.
MAIN - 10
NRG Power DT