Refitting The Wheel Axle Bearing; Refitting The Hub Bearings; Refitting The Ub Cover - PIAGGIO NRG Power DT Workshop Manual

Engine

Refitting the wheel axle bearing

- Heat the half crankcase on the transmission side
using a thermal gun.
- After lubricating its outer strip, insert the bearing
with the special adapter with the aid of a hammer.
- Refit the seeger ring and the oil seal using the 42
x 47 mm adapter and the handle.
Specific tooling
020151Y Air heater
020376Y Adaptor handle
020363Y 20 mm guide
020359Y 42x47-mm adaptor

Refitting the hub bearings

- Remove the wheel axle on the cover and pay at-
tention not to damage the sealing lip of the oil seal
- Apply a thin layer of grease on the two shim
washers of the intermediate gear and fit one on the
cap so that it does not interfere with the wheel axle
gear when placing the transmission shaft

Refitting the ub cover

• Refit the complete wheel axis.
• Refit the intermediate gear being careful of the
two shim adjustments.
• Apply LOCTITE 510 for surfaces on the hub cov-
er and refit it with the complete pulley shaft.
• Insert the 5 screws and tighten them to the pre-
scribed torque.
N.B.
CLEAN THE CONTACT SURFACES OF THE
HUB COVER AND THE HALF CRANKCASE OF
RESIDUE FROM PREVIOUS GASKETS BE-
FORE APPLYING A NEW ONE.
Locking torques (N*m)
ENG - 16
NRG Power DT