To replace the tail light bulbs «F» take out the rubber bulb holder from its fitting and
insert the bulb.
To replace the high-beam bulb «G» and the low-beam bulb «H» take out the bulb
holder from its fitting by turning it anticlockwise. Slide off the bulbs by pressing it slightly
and turning it anticlockwise.
03_36
Headlight adjustment (03_37, 03_38)
Proceed as follows:
1. Position the unloaded scooter, in running order and with the tyres inflated to the
prescribed pressure, onto a flat surface 10 m away from a half-lit white screen; ensure
the axis of the scooter is perpendicular to the screen;
2. Turn on the headlight and check that the limit of the projected light beam is not over
9/10 or below 7/10 of the distance from the ground to the centre of the headlight;
3. If this is not the case, regulate the headlight by turning screw "A".
03_37
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EUROPEAN STANDARDS RE-
GARDING MAXIMUM AND MINIMUM HEIGHT OF LIGHT BEAMS. REFER TO THE
STATUTORY REGULATIONS IN FORCE IN EVERY COUNTRY WHERE THE ve-
hicle IS USED.
03_38
60