Removing The Stanchion; Removing The Damper - PIAGGIO NRG Power DT Workshop Manual

Suspensions
- Remove the wheel axle.
- Remove the screw (4).
- Remove the stanchion (3).
- Remove the dust guard (1).
- Insert the new sealing ring after lubricating the
inside parts of the ring and paying attention not to
damage it.
- Insert the stanchion appIying the recommended
product to the clean surface.
- Lock the screw (4).
Recommended products
Loctite 243 Medium-strength threadlock
Loctite 243 medium-strength threadlock

Removing the stanchion

- Remove the dust guard (1) using a screwdriver
to prise it out.
- Remove the seeger (2) and remove the power
pipe.
N.B.
GREASE THE SPRINGS AND THE BUSHINGS
BEFORE REFITTING, WITH A SMALL QUANTI-
TY OF GREASE (AROUND 3 GR.)
Recommended products
AGIP GREASE MU3 Grease for odometer
transmission gear case
Soap-based lithium grease with NLGI 3; ISO-L-
XBCHA3, DIN K3K-20

Removing the damper

- Remove screw 1 fixing the screw to the stem and
remove the stanchion heating it if necessary with
the specified heater, then remove sealing ring 2
and seeger 3.
- Using nut 4, remove the spring stem and bushing.
The damper is an integral part of the stem and
cannot therefore be overhauled, so if you need to
work on the damper (loss of fork oil), carry out the
SUSP - 4
NRG Power DT