Table of Contents
Advertisement
Helmet compartment lighting bulb
License plate light bulb
Type: Cylindrical
Quantity: 1
Power: 12V - 5W
Type: All glass
Quantity: 1
Power: 12V - 5W
Front light group (03_23, 03_24)
To access the bulbs, undo the screw «A» and remove the headlight assembly col-
lecting the shim washer and the washer.
To replace the high-/low-beam headlight bulb «B», detach the connector, remove the
rubber protection, release the retaining clip and take out the bulb.
To replace the tail light bulb «C», take out the rubber bulb holder and slide off the bulb.
Headlight adjustment (03_25, 03_26)
03_23
In order to carry out the vertical adjustment of the light beam:
1. Place the vehicle, in running order and with the tyres inflated to the prescribed
pressure, on a flat surface 10 m away from a half-lit white screen, and make sure that
the longitudinal axis of the scooter is perpendicular to the screen.
2. Turn on the headlight and check that the borderline of the beam projected on the
screen is not higher than 9/10 or lower than 7/10 of the height of the centre of the
headlight from the ground.
3. Otherwise, loosen the screws «D» and rotate the light until the optimal orientation
is obtained.
03_24
54
Advertisement
Table of Contents
