Centre-Stand; Removal Of Stand Bolt From Bracket; Replacing The Centre-Stand Assy; Calking And Fitting Of Stand Bolt To Bracket - PIAGGIO NRG Power DT Workshop Manual

NRG Power DT

Centre-stand

Removal of stand bolt from bracket

- Remove the stand support bracket from the en-
gine.
- Drill a 5 mm hole in the bracket so that the pin
«P» can come out.

Replacing the centre-stand assy

- Work on the screws shown in the figure.
- When refitting, secure to the prescribed torque.
Locking torques (N*m)
Stand screw torque 18.5 to 19 Nm

Calking and fitting of stand bolt to bracket

- Caulk the end of the pin «P» between the two
punches shown in the figure.
- After caulking it must be possible for the stand to
turn freely.
N.B.
UPON REFITTING USE NEW O-RING AND PIN,
GREASE THE SPRING ATTACHMENTS AND
THE PIN.
Suspensions
SUSP - 9