Plu Descriptor - Sam4s ER-350II Operator's And Programming Manual

PLU Descriptor

If you are using PLUs, the PLU descriptor print the PLU code unless you choose to program a
custom descriptor. For example, the receipt will look like this:
If you wish you can each department descriptor with a custom descriptor, up to 10 characters in
length. For example, you could program your own descriptors like this:
Programming a PLU Descriptor
1. Turn the control lock to the PGM position.
2. Press the @/FOR key.
3. Refer to the "Enter the PLU code, press the PLU key.
4. Code Table" on page 75 and enter the two digits that represent each character you
5. Press the @/FOR key.
6. Enter the PLU number, press the PLU key.
7. Repeat from step 2 for each department you are programming.
8. Press the CASH/TEND key to end programming.
PLU Descriptor Programming Flowchart
@/
FOR
PLU Descriptor Programming Example
Program the descriptor for PLU 1 to say "APPLES"
1. Turn the control lock to the PGM position.
2. Press the @/FOR key.
3. Enter the codes representing the text "APPLES": 2 0 3 5 3 5 3 1 2 4 3 8.
4. Press the @/FOR key.
5. Enter the PLU code, press the PLU key.
ER-350II Electronic Cash Register v1.3
PLU1
PLU23
CIGARETTE
APPLES
wish. You can enter up to 10 character codes for each PLU.
Repeat for each PLU
Up to 10
2-digit
character
codes
T1 $2.99
T1 $1.99
T1 $2.99
T1 $1.99
@/
FOR
PLU
Code
Advanced Programming Instructions • 75
CASH/
PLU
TEND