Table of Contents
Advertisement
Programming Tax
Most sales taxes can be programmed by entering a tax percentage rate. However, in some cases you
may find that tax that is entered as a percentage does not follow exactly the tax chart that apply in
your area. If this is the case, you must enter your tax using tax table programming. This method will
match tax collection exactly to the break points of your tax table. See "Tax Table Programming" on
page 56.
Important Note: After you have entered your tax program, test for accuracy
by entering several transactions of different dollar amounts. Carefully check
to make sure the tax charged by the cash register matches the tax amounts on
the printed tax chart for your area. As a merchant, you are responsible for
accurate tax collection. If the cash register is not calculating tax accurately, or
if you cannot program your tax properly from the information in this manual,
contact your local SAM4s dealer for assistance.
Programming a Tax Rate Percentage
1. Turn the control lock to the PGM position.
2. Enter the rate, with a decimal. 0.000-99.999. It is not necessary to enter proceeding
3. Enter 00.
4. Enter:
5. Press the TAX SHIFT key.
6. Press the CASH/TEND key to end programming.
7. See tax rate program examples on page 14.
Tax Rate Programming Flowchart
Please Note: After programming the tax rate, you must program your
department or departments taxable to calculate tax. See page 15 for
department programming steps.
ER-350II Electronic Cash Register v1.3
zeros. For example, for 6%, enter 06.000 or 6.000.)
1
to set tax rate 1
to set tax rate 2
2
3
to set tax rate 3
.
Tax Rate
TAX
0
0
SHIFT
Tax #
(1-3)
Quick Setup • 13
CASH/
TEND
Advertisement
Table of Contents
