Remote Administration Interface (Rai); Guidelines; Installation - Panasonic DBS 40 Manual

Chapter 5. Peripheral Equipment

Remote Administration Interface (RAI)

Guidelines

l
l
Table 5-2. RAI compatibility

Installation

l
l
l
5-6
The RAT is a modem card that installs on the XC card. The card is used to
remotely administer the system through a trunk line.
Two versions of the RAI card are available. Both versions use 1 Stop bit, 8
data bits, and no parity. The RAI-A card has a fixed baud rate of 300. The
RAI-B card supports both 300 and 1200 baud operation. The following
table shows the transmission rate of each card along with the SCC version
compatibility.
RAI Version/Part No.
RAI-A (VB-43706)
Remove the upper cover of the SCC card.
Jumper 1 (Jl) on the RAI-B controls the transmission rate. When closed,
the transmission rate is switchable from 300 bps to 1200 bps through
system programming. When open, the rate is fixed at 300 bps.
Connect the RAI card to the connector on the SCC card.
The %41-A connects to CN3. RAI-B connects to CN2 and CN3.
Replace the upper cover of the SCC.
Note: To adjust the output level of the RAI, set switch 4 as shown in Figure
5-3.
DBS Manual - Issued 8/l/95
Transmission SCC Compatibility
Parameters
300 bps, 1 stop bit,
8 data bits, no
300 bps/1200 bps, SCC-B only
1 stop bit, 8 data
bits, no parity
Section 300~Installation
.
DBS-70-300