Installation - Panasonic DBS 40 Manual

Section 3004nstallation

Installation

The following procedures describe direct OPX connection and OPX
connection through a CO. Order an OL13C circuit for an OPX through a CO.
Refer to Figure 5-6 on page 5-13 when installing the OPX.
Installing an OPX Station Without Going Through a Central Office
1. Remove the cover from the OPX Adaptor.
2. Remove the cable punch-out plate (Figure 5-12) to make an opening for
Figure 5-S. Cable punch-out i
3. Mount the OPX Adaptor to the wall.
Table 5-5. Maximum distances for OPX Adaptor installation
DBS-70-300
the cables coming into the OPX Adaptor.
To remove the plate, cut the grooves on either side with diagonal shears.
Then bend the plate back and forth with needle-nose pliers to remove it.
de. OPX Adabtor
Note: Table 5-5 shows how far the Adaptor can be located from the DBS.
Wiring gauge
AWG 22
AWG 24
AWG 26
DBS Manual - Issued 8/lY95
Chapter 5. Peripheral Eauioment
Max. distance (in feet) between the DBS and
OPX Adaptor
309
194
122
5-11