Panasonic DBS 40 Manual page 72

Section 300~installation
Installing Tl in a Double Cabinet with the Tl in the Slave
1.
2.
3.
4.
5.
6.
7.
8.
Install the Sync Unit in the master cabinet as described in Steps 1 and 2
under "Installation for a Single Tl."
Install a Tl MDF card in the slave cabinet. (See Step 3 on page 4-23.)
Set Switch 1 on the Tl card. (See Step 4 on page 4-24.)
Install a Tl card in the "EQTRK" slot of the slave cabinet.
Connect the Sync Cable from CNl on the Sync Unit to CN5 on the Tl
card (Figure 4-l 1).
Note: Part Number VB-43564 is used for the Sync Cable when a Tl is
installed only in the slave cabinet of a' two-cabinet system.
At the slave cabinet, connect the cable attached to CN3 on the Tl MDF
card to CN3 on the Tl card (Figure 4-10).
Using an RJ48 cable, connect CNl of the Tl MDF card to the CSU. (See
Figure 4-9 on page 4-25 for RJ48 pinouts.)
At the slave cabinet, connect the ground cable on the Tl MDF card as
shown in Figure 4-10 on page 4-26.
DBS Manual - Issued 8/l/95
Chapter 4. Trunks and Lines
4-27