I
4. Set SW1 on the Tl card according to the following table.
settings for
Table 4-18. Switch
6. Connect the Sync Cable from CNl on the Sync Unit to CN5 on the Tl
7. Connect the cable attached to CN3 on the Tl MDF card to CN3 on the Tl
8. Using an RJ48 cable, connect CNl on the Tl MDF card to the CSU
4-24
These switch settings correspond to the distance between the DBS and the
CSU. To turn a switch on, fiip it to the "up" position.
SWZ on the Tl card
SW
0 to 150 ft.
SW1
On
Off
off
Off
Off
SW6
Off
card.
card (Figure 4-10).
(Figure 4- 10). The following illustration shows CNl pinouts.
Distance from the DBS to the CSU
Off
On
Off
On
Off
On
Off
Off
On
Off
On
Off