Panasonic DBS 40 Manual page 53

Chapter Trunks and Lines
4.
2. Install the loop-start trunk in a trunk slot.
3. Use a standard 50-pin cable to connect the trunks from the MDF to the
Installation with Caller ID
1. Remove the cover from the L-TRK card (VB-435 11A). This cover should
2. Cut strap Jl on the L-TRK card as shown in Figure 4-2.
3. Set switches SW1 through SW8 on the L-'IRK card (VB-43511A) to
IMPORTANT: When caller ID is used, you must correctly set the switches to prevent possible
A
damage to the
4. Attach the Caller ID card to the L-TRK card.
Figure 4-3. Attaching Caller ID Card to the I,-TRK Card
L-TRK Card
5. Install the L-TRK card in a trunk slot.
6. Use a standard 50-pin cable to connect the trunks from the MDF to the
4-8
main trunk connector CNl.
be set aside since it cannot be reinstalled with a Caller ID Board installed.
OFF.
card.
L-TRK
main trunk connector CN 1.
Section 3004nstallation
ID Board