Installing The Cover - IBM System x3250 Problem Determination And Service Manual

7. If you are instructed to return the cover and bezel, follow all packaging

Installing the cover

To install the cover and bezel, complete the following steps.
1. To install the left bezel, if you removed it, insert the tab at the right end of the
2. Make sure that all internal cables are correctly routed.
3. Set the cover on top of the server so that approximately 13 mm (0.5 inch)
4. Slide the cover forward and into position.
5. Slide the server into the rack.
a. From inside the server, press the bezel release latch toward the left side of
the server.
b. Pivot the bezel forward and pull it away from the server.
instructions, and use any packaging materials for shipping that are supplied to
you.
Release
latch
bezel into the front of the chassis and pivot the bezel until it snaps into place.
extends from the rear.
Chapter 4. Removing and replacing server components
69