IBM System x3250 Problem Determination And Service Manual page 92

Note: If a RAID controller or adapter is installed, you might have to reconfigure the
disk arrays after you install or remove hard disk drives. See the documentation that
comes with the adapter for more information.
Removing a simple-swap Serial ATA hard disk drive
Attention:
power from the server before you remove or install a simple-swap hard disk drive.
To remove a simple-swap SATA drive from the bay, complete the following steps.
Hard disk
drive assembly
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure that the server cover is in place and fully closed.
3. Turn off the server and peripheral devices, and disconnect the power cord and
4. Remove the filler panel from the bay.
5. Pull the loops of the drive tray toward each other and pull the tray out of the
Installing a simple-swap Serial ATA hard disk drive
Attention:
power from the server before you remove or install a simple-swap hard disk drive.
To install a simple-swap Serial ATA hard disk drive, complete the following steps.
74
IBM System x3250 Types 4364 and 4365: Problem Determination and Service Guide
Simple-swap hard disk drives are not hot-swappable. Disconnect all
on page 65.
all external cables.
bay.
Simple-swap hard disk drives are not hot-swappable. Disconnect all
SATA hard disk
drive back plate
Filler panel