Installing The Backplane Or Back Plate (3.5-Inch Drives) - IBM System x3250 Problem Determination And Service Manual

Note: The following illustration shows removing the hot-swap SAS/SATA backplane.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the server from the rack and place it on a flat, static-protective surface.
4. Pull the hard disk drives out of the server slightly to disengage them from the
5. Remove the cover (see "Removing the cover" on page 68).
6. Disconnect the backplane or back plate cables:
7. Rotate (lift) the air deflector out of the way.
8. Lift the backplane or back plate out of the server slightly; then, disconnect the
9. If you are instructed to return the backplane or back plate, follow all packaging

Installing the backplane or back plate (3.5-inch drives)

To install the replacement 3.5-inch hot-swap drives backplane or simple-swap SATA
drives back plate, complete the following steps.
Note: The following illustration shows installing the hot-swap SAS/SATA backplane.
90
IBM System x3250 Types 4364 and 4365: Problem Determination and Service Guide
Air deflector
on page 65.
all external cables necessary to replace the device.
backplane or back plate.
v If the server is a hot-swap model, or you have installed an optional SATA
RAID kit, disconnect the SAS/SATA controller cable from the backplane or
back plate.
v If the server is a simple-swap model, disconnect the SATA cables from the
system board.
power cable and remove the backplane or back plate.
instructions, and use any packaging materials for shipping that are supplied to
you.
Connectors
Guide channel