Removing The Operator Information Panel Assembly; Installing The Operator Information Panel Assembly - IBM System x3250 Problem Determination And Service Manual

Removing the operator information panel assembly

To remove the operator information panel assembly, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the server from the rack and remove the cover (see "Removing the
4. Disconnect both cables from the operator information panel board.
5. Remove the screws that secure the operator information panel assembly to the
6. Lift the operator information panel assembly out of the server.
7. If you are instructed to return the operator information panel assembly, follow all

Installing the operator information panel assembly

To install the replacement operator information panel assembly, complete the
following steps:
1. Guide the operator information panel assembly into position on top of the
2. Use the screws that you removed in step 5 of "Removing the operator
3. Connect the light panel cable and front USB cable to the operator information
84
IBM System x3250 Types 4364 and 4365: Problem Determination and Service Guide
v Set the power-on password.
v Reconfigure the server.
See "Using the Configuration/Setup Utility program" on page 108 for details.
on page 65.
all external cables necessary to replace the device.
cover" on page 68).
CD/DVD bay housing.
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
CD/DVD bay housing. Make sure that the LEDs and the USB connectors are
aligned with the openings in the bezel and that the holes in the board align with
the screw holes in the top of the bay housing.
information panel assembly" to secure the operator information panel assembly
onto the top of the CD/DVD bay housing.
panel board.