Lenovo ThinkServer RD450 User Manual And Hardware Maintenance Manual page 97

• "Installing a PCIe card on the system board" on page 87
Adjusting the card-retaining bracket
Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 59.
Note: This topic applies when the length of the PCIe card to be installed is either of the following:
• 176.4 mm (6.94 inches)
• From 185 mm (7.28 inches) to 220 mm (8.66 inches)
To adjust the card-retaining bracket, do the following:
1. Remove the three screws that secure the card-retaining bracket. Then, move the card-retaining bracket
to the direction as shown.
Figure 49. Removing the screws to adjust the card-retaining bracket
2. Do one of the following:
.
Chapter 6 Replacing hardware
83