System Remote_Management Telnet Configure - NETGEAR ProSafe FVS318N Cli Reference Manual

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Keyword Associated Keyword to
Select or Parameter to Type
Everyone, IP_Range, or
access_type6
To_this_PC_only
from_address6 ipv6-address
end_address6 ipv6-address
only_this_pc_ip6 ipaddress
port number
Command example:
FVS318N> system remote_management https configure
system-config[https]> ip_version IPv4
system-config[https]> enable_ipv4 Y
system-config[https]> access_type Everyone
system-config[https]> port 445
system-config[https]> save
Related show command:

system remote_management telnet configure

This command configures remote management over Telnet. After you have issued the
system remote_management telnet configure command, you enter the
system-config [telnet] mode, and then you can configure one keyword and associated
parameter or associated keyword at a time in the order that you prefer.
show system remote_management setup
System Mode Configuration Commands
146
Description
Specifies the type of access:
• Everyone. Enables access to all IP addresses.
You do not need to configure any IP address.
• IP_Range. Enables access to a range of IP
addresses. You also need to configure the
from_address6 and end_address6 keywords
and associated parameters.
• To_this_PC_only. Enables access to a single IP
address. You also need to configure the
only_this_pc_ip6 keyword and associated
parameter.
The start IP address if you have set the
access_type6 keyword to IP_Range.
The end IP address if you have set the
access_type6 keyword to IP_Range.
The single IP address if you have set the
access_type6 keyword to To_this_PC_only.
The number of the port through which access is
allowed.