NETGEAR ProSafe FVS318N Cli Reference Manual page 156

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Keyword
time_hour
time_meridian
time_minute
send_email_report
Action when limit is reached
block_type
send_email_alert
Command example:
FVS318N> system traffic_meter configure
system-config[traffic-meter]> enable Y
system-config[traffic-meter]> limit_type Downloadonly
system-config[traffic-meter]> monthly_limit 150000
system-config[traffic-meter]> increase_limit_enable Y
system-config[traffic-meter]> increase_limit_by 50000
system-config[traffic-meter]> counter SpecificTime
system-config[traffic-meter]> day_of_month 01
system-config[traffic-meter]> time_hour 00
system-config[traffic-meter]> time_minute 00
system-config[traffic-meter]> send_email_report Y
system-config[traffic-meter]> block_type Block-all-traffic-except-email
system-config[traffic-meter]> send_email_alert Y
system-config[traffic-meter]> save
Related show command:
Associated Keyword to Select or
Parameter to Type
hour
AM or PM
minutes
Y or N
Block-all-traffic, or
Block-all-traffic-except-email
Y or N
show system traffic_meter setup
System Mode Configuration Commands
156
Description
The hour in the format HH (00 to 12)
that the traffic counter restarts. This
keyword applies only when you have
set the counter keyword to
SpecificTime.
The meridiem for the hour that the
traffic counter restarts. This keyword
applies only when you have set the
counter keyword to
SpecificTime.
The minutes in the format MM (00 to
59) that the traffic counter restarts.
This keyword applies only when you
have set the counter keyword to
SpecificTime.
Specifies whether or not an email
report is sent when the traffic counter
restarts.
Specifies the type of traffic blocking
after the meter has exceeded the
configured limit.
Specifies whether or not an email alert
is sent when the traffic limit is
reached.